# Pipe Repair and Repiping for Greenwood, IN Homes > Pipe repair and repiping in Greenwood, IN: Indiana American Water lead line rules, the $75 City plumbing permit, and 1960s-70s copper next to newer homes. URL: https://circlecityrepipeindy.com/service-areas/greenwood/ Last Updated: October 30, 2026 Permit City of Greenwood Community Development Services issues the plumbing permit (City of Greenwood (Johnson County)). Code 2012 Indiana Plumbing Code or 2020 Indiana Residential Code (named on the permit application) sets the rules for the water piping. Water Indiana American Water (Johnson County system) supplies the water. Local ## What starts the work in Greenwood ### Indiana American Water is working on your street During a utility project, lead service lines and galvanized lines that follow lead are replaced at no direct cost to the customer, once the owner signs an access agreement. The plumbing past the inside valve is not part of it. ### You want the lead line out before any project is planned An owner can replace the customer-owned portion through their own contractor, at their own expense and without reimbursement. The utility asks owners to contact it first. ### Copper from the 1960s or 1970s has started to leak A first pinhole is a repair. A run that keeps leaking, or green staining at several joints, is the point to price replacing that run or the whole system. ### A remodel that adds more than one trade Greenwood charges each trade permit separately, with a combined cap, so plumbing added to an electrical or structural remodel goes on the same application. Index ## Services in Greenwood - Service [Whole-house repiping](https://circlecityrepipeindy.com/whole-house-repiping/)Every hot and cold supply line from the main shutoff to the fixtures, replaced in PEX or copper, inspected under a plumbing permit and pressure tested before the walls close. - Service [Copper pipe repair](https://circlecityrepipeindy.com/copper-pipe-repair/)Pinhole leaks, weeping solder joints and corroded fittings on copper supply pipe, repaired with matched copper and lead-free joints, and the pipe around them checked for what comes next. - Service [Copper repiping](https://circlecityrepipeindy.com/copper-repiping/)Hot and cold supply lines replaced in copper tube, with the tube type and the joining method, press-fit or lead-free solder, named in the written scope. - Service [Lead service line replacement](https://circlecityrepipeindy.com/lead-service-line-replacement/)Lead or galvanized service lines replaced from the house to the property line through a Citizens-bonded plumber, coordinated with the utility's own work in the street. - Service [Water leak detection](https://circlecityrepipeindy.com/water-leak-detection/)Hidden supply leaks located from the meter inward, with the method matched to the pipe, and a written finding of where the leak is before anything is opened. A Greenwood owner who reads about lead service lines is usually reading Citizens Energy Group’s rules, and those do not apply south of the county line. Water in Greenwood comes from Indiana American Water, an investor-owned utility with its own lead line policy, and permits come from the City’s own Community Development Services. [Circle City Repipe](https://circlecityrepipeindy.com/) offers repiping in Greenwood, IN, along with copper pipe repair, leak detection and the interior side of lead line work, with every job carried out by licensed and insured contractors. ## Indiana American Water and the lead line The EPA’s drinking water records list Indiana American Water’s Johnson County system for Greenwood, serving about 86,800 people. Its customer guide on lead in water service lines sets out terms that differ from the Citizens program in Indianapolis in ways that matter to the order of work. The utility replaces lead service lines, and galvanized lines downstream of lead, at no direct cost to the customer while it is upgrading water infrastructure in the area. When the customer-owned portion is lead, the property owner has to sign an access agreement. The replacement covers any lead portion from the main to the shut-off valve inside the property, and the utility installs a valve if the house has none. Lead plumbing and fixtures past that valve stay with the owner. The utility does not test individual customers’ water for lead, though it provides a test kit after a replacement and a pitcher filter for six months. Outside a planned project, an owner may replace their own portion through their own contractor, at their own expense, and the utility does not reimburse it; it asks owners to contact it first. Indiana American Water describes its own portion as running from the main to the outside shut-off or meter pit, and the customer’s from that valve to the indoor plumbing. Its service line map is the place to check what its records show for an address. The [lead service line replacement](https://circlecityrepipeindy.com/lead-service-line-replacement/) page covers the owner-side work, and the [Citizens program guide](https://circlecityrepipeindy.com/guide/citizens-energy-lead-service-line-program/) is useful mainly as a contrast for anyone comparing notes with Indianapolis neighbors. ## A city of 1960s copper and newer subdivisions Greenwood’s housing is mostly recent. Census Bureau survey data, from the American Community Survey, put Greenwood’s median year built at 1996, with 73.1% of homes dating from 1980 or later. The older layer is thinner but real: 17.9% were built between 1960 and 1979, and about 9% before 1960. The Old Town Historic District along Madison Avenue marks where the city began, though age is only a hint about any one house there. Roughly seven in ten homes are single-unit houses. Those eras point to different questions. Copper was the standard supply pipe for houses of the 1960s and 1970s, and after decades of flow it can erode from the inside out until it pinholes; [why one pinhole leak tends to lead to another](https://circlecityrepipeindy.com/guide/copper-pinhole-leaks/) is what changes the repair-or-replace math. Houses built before 1986 may also have lead solder at the copper joints, a point Citizens raises for its own customers and one that applies to copper of that age anywhere. Older houses near the historic core may still have galvanized steel in places. In the newer subdivisions the supply pipe is likely to be plastic from the start, so a [water leak detection](https://circlecityrepipeindy.com/water-leak-detection/) visit or one repair is the likelier job than a repipe. What any one house has is found at the meter, using the [guide to identifying pipe material](https://circlecityrepipeindy.com/guide/how-to-identify-pipe-material/) as a check. Water chemistry is the one local piece this page leaves out. Indiana American Water’s annual water quality report for the Johnson County system is the source for hardness and treatment, and those figures are not repeated here without it. ## The City permit and what it costs Greenwood’s Community Development Services issues residential permits, and its residential application lists plumbing among the trades a permit can cover. Its current form puts the fee for a residential plumbing permit at $75, with any combination of trade permits capped at $225. Fees are collected when the permit is issued, not at application, and a plumbing plan is required when plumbing is included. The same form asks the applicant to name the code the work follows: the 2020 Indiana Residential Code or the 2012 Indiana Plumbing Code. A repipe on its own is normally the plumbing line; a remodel that also needs electrical or structural work goes on the same application under the cap. ## Order of work in a Greenwood house In Greenwood the first look is at the inside valve the utility’s rules turn on, along with the meter setting and whatever material the service line is where it comes through the wall. Static pressure and running flow get recorded at a low fixture and a high one, hot side and cold side. A written price, scope and opening list follow, and only then does any cutting start. Where a house is a single-story ranch over a crawlspace or basement the main and branches run below the floor, which keeps wall openings few. Where a house sits on a slab, new supply lines are routed through the attic and down interior walls instead of through the concrete, kept inside the insulation so they do not freeze. A two-story house adds the climb to an upstairs bath, usually through a closet or chase. Cutover happens a section at a time, so the household has water most of the day. The rough-in gets its inspection with the walls open; pressure testing and flushing follow, and the water heater and fixtures are reconnected last. An old gate-style or stuck main valve is swapped during the shutdown, and the patching follows the written list of openings. ## Planning the interior and the service line together The Indiana American Water rules leave a gap at the inside valve. Outside it, the utility replaces lead during its own projects; inside it, everything is the owner’s. If a house has lead or old galvanized plumbing past the valve, replacing the service line alone leaves that interior pipe in place, and a repipe done first can be sequenced so the new interior connects cleanly to whatever the utility installs later. Where the interior is copper in decent shape, a [copper pipe repair](https://circlecityrepipeindy.com/copper-pipe-repair/) may be all the house needs; where leaks keep returning, [copper repiping](https://circlecityrepipeindy.com/copper-repiping/) or a [whole-house repipe](https://circlecityrepipeindy.com/whole-house-repiping/) is the honest scope. Greenwood uses the same whole-house figure as the rest of the metro, $4,000 to $15,000 or more, and the [Indianapolis repipe cost guide](https://circlecityrepipeindy.com/guide/repiping-cost-indianapolis/) explains what moves a house within it. ## North of Greenwood [Beech Grove](https://circlecityrepipeindy.com/service-areas/beech-grove/) is the closest excluded city in Marion County, with its own building office on Citizens water. [Fountain Square](https://circlecityrepipeindy.com/service-areas/fountain-square/) and [Irvington](https://circlecityrepipeindy.com/service-areas/irvington/) have older housing and Citizens’ lead line program. The [service areas page](https://circlecityrepipeindy.com/service-areas/) has the full list, from the north suburbs to the south side. Where ## Neighborhoods and coverage Neighborhoods - Old Town Historic District Landmarks - Greenwood Park Mall - Indy South Greenwood Airport Routes - US 31 - Interstate 65 - Madison Avenue Questions ## Greenwood questions - Q01 What does it cost to repipe a house in Greenwood, including the permit? A whole-house repipe falls in the typical Indianapolis-area range of $4,000 to $15,000 or more; size, the number of baths and copper versus PEX decide where in it a house lands. Greenwood's Community Development Services charges $75 for a residential plumbing permit, with any combination of trade permits capped at $225, and the fee is collected when the permit is issued rather than when you apply. - Q02 Will Indiana American Water pay to replace my lead service line in Greenwood? Only as part of its own infrastructure work in your area. Indiana American Water replaces lead service lines, and galvanized lines that follow lead, at no direct cost to the customer while it is upgrading the system nearby, once the owner signs an access agreement. If you replace your portion yourself outside a planned project, the cost is yours and is not reimbursed. - Q03 Does Indiana American Water replace the lead plumbing inside my house? No. Its replacement covers any lead portion from the main to the shut-off valve inside the property, and it installs a valve if there is none. Lead plumbing and fixtures beyond that valve are the property owner's responsibility, which is where an interior repipe comes in. - Q04 Which part of a Greenwood water service line do I own? Indiana American Water describes the utility-owned portion as running from the main to the outside shut-off or meter pit, and the customer-owned portion from that valve to the indoor plumbing. Leaks and replacement on the customer side are the owner's to arrange, and the utility suggests contacting it before replacing that portion. - Q05 Do I need a plumbing plan for a repipe permit in Greenwood? Greenwood's residential permit application lists plumbing among the trades a permit can cover and asks for a plumbing plan when plumbing is included. The same form asks which code the work follows, either the 2020 Indiana Residential Code or the 2012 Indiana Plumbing Code. The exact drawings needed for a given repipe are confirmed per project. Read ## Related guides Learn 01 How does the Citizens Energy lead service line replacement program work? What Citizens' letter means, how to look up your own line, what happens when the program reaches your street, what it costs if you go first, and what it leaves inside the house. Guide → Learn 02 What causes pinhole leaks in copper pipes? There is no single cause of copper pinholes, and anyone who names one without looking at the pipe is guessing. This guide goes through each mechanism, the clues that point to it, what a temporary fix can and can't do, and when the pattern says repipe. Guide → Learn 03 How to identify lead pipes and the other pipe in your house A step-by-step check you can do at the water meter with a coin and a magnet, the way Citizens Energy Group and the EPA describe it, then how to read the rest of the pipe in the house and what each material changes. Guide → Cost Guide 04 How much does a repipe cost in Indianapolis? The typical Indianapolis-area range for a whole-house repipe, what sits inside that number, the City permit fee, why local labor costs more than the national median, and how to read two quotes for the same house. Guide → Nearby ## Nearby service areas - City of Beech Grove (excluded city) [Beech Grove](https://circlecityrepipeindy.com/service-areas/beech-grove/)Permits: City of Beech Grove Building Commissioner - City of Indianapolis (Consolidated City) [Fountain Square](https://circlecityrepipeindy.com/service-areas/fountain-square/)Permits: City of Indianapolis Department of Business and Neighborhood Services (DBNS) - City of Indianapolis (Consolidated City) [Irvington](https://circlecityrepipeindy.com/service-areas/irvington/)Permits: City of Indianapolis Department of Business and Neighborhood Services (DBNS) ## Get an estimate in Greenwood